Some inter-canister calls are no longer working, and the dashboard isn’t showing any canisters on the subnet. Is there an issue on the European Subnet?
We got:
addTaskActivityEntry failed: could not perform remote call
[3178. 2026-11-04T12:55:45.933989891Z]: (bytes) 0xe29aa0efb88f204661696c656420746f20757064617465207461736b20776f72647320696e206261636b656e642d696e64657865723a20636f756c64206e6f7420706572666f726d2072656d6f74652063616c6c
I think the “could not perform remote call” error has been occurring since yesterday.
This seems to be a motoko error when it encounters transient errors when trying to make a call.
I don’t see anything in the subnet that could cause transient xnet errors, or anything that changed yesterday. I did however see something similar in the past when a canister was very low on cycles. Could you try topping up your canister a bit more? Alternatively, if you yourself are sending over 500 messages at once the queue between your canisters might be full.
Thank you very much for the tip! I quickly topped up the canister with 2T cycles and it started working again. We only send a few messages at a time, not 500. It looks like a balance of roughly 2T cycles is too low, so I need to keep it above that level.